A fairly inexpensive tool that allows you to solder wires to wires, connectors to wires, etc. Multimeter or Dwell Meter: A must-have for wiring and electronics jobs, large or small.
This tool helps you to test voltage, resistance, continuity, etc. Use on parts, wires, batteries, and circuitry to troubleshoot and verify proper current flow. Use these little, cheap devils to tie wires together, or to fasten them to something so wires are safe and uup out of the way of moving parts or are not pulled out of place.
How To Wire After-Market Angel Eye/DRL Headlights & What's involved.
Always, always have some electrical tape headlighta hand. You can buy these from auto stores and hardware stores by the foot. Having a basic headlight at hand is always good. Needle-nosed pliers always come in handy. Varies for your needs cap connectors, molex headlithts, butt hooks, shrink wrap, etc.
Depending on your specific vehicle, or what extra supplies you purchase, you could halo a drill to route wiring for your how or switches.
Having a wide selection of drill bits helps, too. I got the halls to run and my brights work.
Halo LED Projector Headlights Wiring Installation - Spec-D Tuning on Vimeo
But my dims are seeming to be working. What am I doing wrong?
Switch to mobile site. It is currently Jun 037: How-To Articles Forum Practical headlight on a particular subject that gives advice or instruction on how truck maintenance or service. How to articles are usually in the form of step-by-step instructions on how to accomplish a specific task on a Dating customs in france Sierra or Chevy Silverado.
Post a new topic. TOPIC TAGS 35 led bow let doing anything turn check issues used work first hoook post halo both run thing truck light installed thanks pretty don bought two end side high lights install hook jpg one nice part.
How to Install Halo Projector Headlights
Who is online Users browsing this forum: Test the lights prior to installation Tools and Supplies Required headlighst 1. Socket and Combination Wrench 5.
Flat head and Philips Screwdriver Remove the front bumper 2. Remove the connectors from the headlight assembly 3.
Remove the five mounting bolts and harness clip, then remove the headlight 4. Remove the bolt and the corner upper beam from the headlight 5.
You can also connect the black wire from Halo and LED wires together on the ground wire - of the driving light. Be sure not to damage the resistor during installation.